How do I enable the LTE modem inside an IG60-BL654-LTE ?

The LTE modem inside an IG60-BL654-LTE can be enable with the following command:

echo 0 > /sys/devices/platform/gpio/lte_on/value


A succesfull action will be indicated by two USB interfaces appearing:

# ip addr show

1: lo: mtu 65536 qdisc noqueue state UNKNOWN group default qlen 1000

    link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00

    inet 127.0.0.1/8 scope host lo

       valid_lft forever preferred_lft forever

    inet6 ::1/128 scope host

       valid_lft forever preferred_lft forever

2: eth0: mtu 1500 qdisc pfifo_fast state DOWN group default qlen 1000

    link/ether fa:87:d7:c4:c1:e3 brd ff:ff:ff:ff:ff:ff

3: eth1: mtu 1500 qdisc pfifo_fast state DOWN group default qlen 1000

    link/ether 36:42:a6:34:a7:4e brd ff:ff:ff:ff:ff:ff

4: wlan0: mtu 1500 qdisc mq state DOWN group default qlen 1000

    link/ether c0:ee:40:44:e1:b4 brd ff:ff:ff:ff:ff:ff

5: usb0: mtu 1500 qdisc pfifo_fast state DOWN group default qlen 1000

    link/ether fa:96:11:12:13:14 brd ff:ff:ff:ff:ff:ff

6: usb1: mtu 1500 qdisc pfifo_fast state DOWN group default qlen 1000

    link/ether fa:96:11:12:13:16 brd ff:ff:ff:ff:ff:ff


Only usb0 is used by the LTE modem. usb1 can be ignored.

Categories

Products

Parts