Bluesuite is a very old program supplied by CSR for testing and configuration of its legacy Bluetooth modules. Bluesuite Bluetest3 is often used for RF testing where the DUT is put into BCSP mode before running Blutest3.

If Bluetest3 crashes with an "array" error you may have a conflict or issue with your .net installation. You may be able to fix the issue by removing all versions of .net but please speak to your IT department first as this may cause issues with other software.

In general, cleaning the populated modules is strongly discouraged. Residuals under the module cannot be easily removed with any cleaning process. 

• Cleaning with water can lead to capillary effects where water is absorbed into the gap between the host board and the module. The combination of soldering flux residuals and encapsulated water could lead to short circuits between neighboring pads. Water could also damage any stickers or labels.
• Cleaning with alcohol or a similar organic solvent will likely flood soldering flux residuals into the RF shield, which is not accessible for post-washing inspection. The solvent could also damage any stickers or labels.
• Ultrasonic cleaning could damage the module permanently.

However, if water washing is required you will need to use deionized water. We do not recommend chemical cleaning and cannot guarantee it will not damage the modules. If you MUST clean PCB with chemicals it is recommended that you test on one board and then confirm the module still works after the process, prior to adding it to production, while understanding the above affects washing the populated PCBs can have on the module.

Our fully-embedded modules have a throughput of around 300-360 kbps.  They have an on-board Bluetooth stack and do all of the Bluetooth processing themselves. Bluetooth 2.1 + EDR has a practical transfer rate of 2.1 Mbit/s, but this is not possible on a small embedded module that does not have a powerful PC-type processor.

S Registers need to be set on the Ezurio Terminal to enable Multipoint mode on the BT730. To do this, follow these steps:

Start Ezurio Terminal

Enter “ATS127=0x200” (this will enable Multipoint mode)

Enter “AT&W” to save/write your settings

Power cycle the BT730 then start the Multipoint Terminal

Additional information on Multipoint can be found in Chapter 2 of the Firmware User Guide.