Bluesuite is a very old program supplied by CSR for testing and configuration of its legacy Bluetooth modules. Bluesuite Bluetest3 is often used for RF testing where the DUT is put into BCSP mode before running Blutest3.

If Bluetest3 crashes with an "array" error you may have a conflict or issue with your .net installation. You may be able to fix the issue by removing all versions of .net but please speak to your IT department first as this may cause issues with other software.

Use of the LC3 codec is included in the Bluetooth product licence when you qualify your product. No additional licence fees are required.

Yes, you need to qualify/list any product that uses BT SIG intellectual property, even if you do not use the logo or require interoperability with other BT devices. see here for more details. Qualify Your Product | Bluetooth® Technology Website

 

In general, cleaning the populated modules is strongly discouraged. Residuals under the module cannot be easily removed with any cleaning process. 

• Cleaning with water can lead to capillary effects where water is absorbed into the gap between the host board and the module. The combination of soldering flux residuals and encapsulated water could lead to short circuits between neighboring pads. Water could also damage any stickers or labels.
• Cleaning with alcohol or a similar organic solvent will likely flood soldering flux residuals into the RF shield, which is not accessible for post-washing inspection. The solvent could also damage any stickers or labels.
• Ultrasonic cleaning could damage the module permanently.

However, if water washing is required you will need to use deionized water. We do not recommend chemical cleaning and cannot guarantee it will not damage the modules. If you MUST clean PCB with chemicals it is recommended that you test on one board and then confirm the module still works after the process, prior to adding it to production, while understanding the above affects washing the populated PCBs can have on the module.

Our fully-embedded modules have a throughput of around 300-360 kbps.  They have an on-board Bluetooth stack and do all of the Bluetooth processing themselves. Bluetooth 2.1 + EDR has a practical transfer rate of 2.1 Mbit/s, but this is not possible on a small embedded module that does not have a powerful PC-type processor. 

For more information on the throughput of the BT740, see the following application note: BTM44X Enhanced Data Module: Throughput Analysis.  The throughput analysis on the BTM44X is also relevant to the BT740.

While the power adjustment cannot be done manually, the radio automatically adjusts the Tx power based on the RSSI and Golden Receive Power Range values. For more information on this, please review the following guide: User Guide - BT740 Firmware.pdf